Potentiometer delivers flickering - jumping inputs (ClubSport Handbrake)

In order to cross out an issue on the hardware side, we recommend performing the following:

1. Remove the top cover of the handbrake by following the instructions mentioned under point number 4 in the quick guide. This link will take you to the quick guide.

2. With the potentiometer now visible, use some compressed air to clean the component.

3. Remount the top cover of the handbrake, and test the unit once again in the Fanatec Control Panel.

4. Once you have performed the steps listed above, open the Fanatec Control Panel, and verify the proper functionality of your device(s). We also suggest double-checking in game.

In case the issue is still persisting, or you are not able to perform the steps mentioned, we advise opening a support ticket. In order to speed up the process, it would be helpful if you could also provide us with the following additional information.

- Did the issue occur out of the box?

- A short video illustrating the issue.